led downlight is broken how to replace - living room led spot light is not bright disassembly maintenance method

led downlight is broken how to replace - living room led spot light is not bright disassembly maintenance method

Barrel ceiling lamp installation is the essential part of the whole household lighting, normally we will when install condole top predict the number of installed good canister light, and tube light with the installation of the canister light directly distance, canister light distance selection can be reference for other articles for understanding, followed by opening the installation, but tube lamp installed not bad, Once the downlight is broken, how to replace it, and the living room led spot light is not on, how to remove and repair it? The following comfortable 100 network editor will introduce the embedded downlight replacement and maintenance steps.

1. Prepare the tools required for the replacement and maintenance of led downlights. The common tools for the replacement and maintenance of led downlights are: electric tape, a set of LED downlights of the same model, pliers and, if necessary, a small hand saw.

2. Turn off the power and slowly buckle down the lamp. Pay attention to the spring clip on the lamp.

3, and then first disassemble the connector, replace the lamp cap, the driver does not move, open the light switch if the light is not bright can be sure that the driver is faulty, replace the driver.

4. At this time, turn off the light switch (for safety), it is better to turn off the main power supply, and then unplug the power supply wire of the drive (directly cut short can also be), and then take off the bad drive and then peel the new power input segment of the drive, and peel the two lamp wires.

5. Let one of the drive power cables be wrapped around one of the lamp power cables (lighting power does not know whether positive or negative), and then stick with electrical tape. The other one is also connected and wrapped with electrical tape.

6, is about to be completed, the next power experiment, turn on and off the light on, if not on repeat the above steps but not to replace the driver but directly replace the led downlight can be!